Zoom: hover, original: click

Decoder DH10C-4 2nd generation 6 pin NEM 651 DCC + Selectrix Doehler & Haass DH10C-4

from 32.99 EUR
Incl. 19% VAT., excl. shipping
local_shippingDelivery time: 4-21 working days
CategoriesDecoder, Control
Decoder standardyes
The latest version with the latest software is always supplied!

The software, firmware and sound data download can be obtained from the Doehler & Haass website .

Product features and functions
- For optional operation with conventional direct current driving device, digital systems according to SelecTRIX 1 and 2 or according to NMRA standard (DCC)
-The switchover between analog and digital operation takes place automatically
-The last programmed system is used in digital mode (it is not switched automatically!)
-SelecTRIX 1 31 speed steps, 100 addresses
-SelecTRIX 2 127 speed steps, 10,000 addresses, 16 additional functions
-DCC Short addresses (1-127), long addresses (0001-9999), with 14, 28, 126 speed steps
- The latest generation of load control, resulting in particularly smooth control behavior
-Various control variants for optimal adaptation to the engine
-Internally 127 speed steps
-Adjustable motor frequency (low frequency, 16 kHz, 32 kHz)
-Block section operation with simple diodes in digital operation
-Light and function outputs can be dimmed and activated analogously
- Shunting
-Motor, light and track connections can be exchanged electronically
-All function outputs are freely programmable
-Temperature protection
-Reset function for DCC and SX2
-Update capability of the decoder
-The update (the firmware download from the Internet is free of charge) is possible with the decoder installed on the track (no opening of the vehicle necessary) and is carried out either via the FCC digital center or the programmer. If no corresponding hardware is available, Doehler & Haass will provide a programmer on loan on request.

The DH10C vehicle decoder supports braking with asymmetrical digital voltage (four diodes in series and one anti-parallel diode, Lenz ABC), slow travel (with suitable brake modules) and bidirectional communication (locomotive address feedback in DCC operation, RailCom®).

A connected SUSI sound module must be removed for SX1 programming. It is sufficient to interrupt the supply voltage (red wire) for the time of the SX1 programming. The SX2 or DCC programming is not affected by this.

Technical data (2nd generation) DH10C
Dimensions [mm] 12.7 x 8.9 x 1.4
Total load 1.5 A
Maximum motor current 1.5 A.
Maximum driving voltage 30 V.
Function outputs light: LV, LR (dimmable) 150 mA each
Function outputs: AUX1, AUX2 (dimmable) 300 mA each
Function outputs: AUX3, AUX4 1.0 A each
Function outputs: AUX5, AUX6 With SUSI interface (if AUX5 / AUX6 deactivated) unamplified *)

Connection variants:
-DH10C-0 Without connecting wires
-DH10C-1 With ribbon cable for standard socket NEM651
-DH10C-2 With connection cable for standard socket NEM651
-DH10C-3 With pigtail
-DH10C-4 6-pin plug connector for direct plugging (NEM651)

This model is not a toy. Not suitable for children under 14 years!