Lasercut processing

Building laser-cut building models from graphic cardboard only differs from conventional plastic kits in a few ways. If you take the following points into account, you will have the best conditions for an excellent model building experience and result with laser cut models:

 

Cutting

• Always use a sharp scalpel or a fine-bladed cutter.
• Always cut straight and vertically.
• Cut out the parts step by step according to the construction instructions. The parts are not numbered in the frame!

Folding

• Before folding, score the fold lines with a sharp blade to prevent the engraving from chipping.
• Use a folding aid (e.g. a ruler).

Glueing

• Remove any smoke from cut edges with a soft cloth or a fiberglass eraser.
• Use suitable glue.
• We recommend the Lasercut Kit Glue (AD87) and - for parts that need to be glued very quickly - Roket Card Glue (AD57) or Super Phatic (AD21) from Deluxe Materials.
• Use a toothpick or brush to apply the glue.
• If too much glue was used, it can be removed with a toothpick.
• Only stick windows on the edges.

Illuminate

• Study the construction instructions and decide when the lighting should be installed before gluing.

Painting and aging

• Always use high-quality, non-thin acrylic or enamel paints.
• If necessary, prime with Enamel or Titanium primer.
• Age the kit with pigments and enamel-based aging products.